This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
openocd:starting_openocd [2020/12/09 22:00] – [Starting OpenOCD] ursgraf | openocd:starting_openocd [2020/12/09 22:02] – ursgraf | ||
---|---|---|---|
Line 10: | Line 10: | ||
* On the Microzed board start '' | * On the Microzed board start '' | ||
- | These commands will | ||
- | With a telnet connection on localhost: | ||
- | |||
- | The gdb connects over port 3333. | ||
===== Linux ===== | ===== Linux ===== | ||
- | Run OpenOCD with the correct config file: | + | Navigate to your '' |
- | cd / | + | * On the Zybo board start with '' |
- | sudo openocd -f microzedboard.cfg or sudo openocd -f digilent_zyboboard.cfg | + | * On the Microzed board start with '' |