openocd:installation
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| openocd:installation [2020/09/05 10:16] – [Installation of the USB driver] ursgraf | openocd:installation [2020/12/09 21:46] (current) – removed ursgraf | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== Installation of the OpenOCD toolchain ====== | ||
| - | OpenOCD can be installed on Windows, Linux and OS-X. Here, the description is limited to Windows. | ||
| - | |||
| - | In order to use OpenOCD, the correct USB drivers must be installed. We suggest using [[http:// | ||
| - | |||
| - | ===== Installation of the USB driver ===== | ||
| - | - Download the [[http:// | ||
| - | - Connect your FT2232 based programmer, e.g. the JTAG-HS3. If you use the Zybo board, connect the board directly as it has the programmer already packed on the board. | ||
| - | - Identify the USB serial converter, which connects to the JTAG bus. Depending on your actual board this will be | ||
| - | * Avnet MicroZed: Device name: Digilent USB Device, Vendor ID = 0403, Device ID = 6014 \\ {{: | ||
| - | * Digilent Zybo: Device name: USB Serial Converter A, Vendor ID = 0403, Device ID = 6010, Interface = 00 \\ {{: | ||
| - | - Right-click on the device and select the WinUSB driver to install the driver | ||
| - | - If you want to reinstall the default driver choose "// | ||
| - | ===== Installation of OpenOCD ===== | ||
| - | - You can either compile OpenOCD from the [[http:// | ||
| - | - Extract the archive to your computer | ||
| - | - The executable binary is located under: '' | ||
| - | - The user manual is located under: '' | ||
| - | - Get {{ : | ||
openocd/installation.1599293767.txt.gz · Last modified: 2020/09/05 10:16 by ursgraf
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
