openocd:installation
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| openocd:installation [2018/08/24 16:09] – mgehrig2 | openocd:installation [2018/10/12 09:34] – [Installation of the USB driver] ursgraf | ||
|---|---|---|---|
| Line 5: | Line 5: | ||
| ===== Installation of the USB driver ===== | ===== Installation of the USB driver ===== | ||
| - | - [[ http:// | + | - [[ http:// |
| - Connect your FT2232 based programmer. If you use the Zybo board, connect the board. | - Connect your FT2232 based programmer. If you use the Zybo board, connect the board. | ||
| - Identify the USB serial converter, which connects to the JTAG bus | - Identify the USB serial converter, which connects to the JTAG bus | ||
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
