This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
openocd:installation [2018/08/24 15:25] – mgehrig2 | openocd:installation [2018/10/12 09:34] – [Installation of the USB driver] ursgraf | ||
---|---|---|---|
Line 5: | Line 5: | ||
===== Installation of the USB driver ===== | ===== Installation of the USB driver ===== | ||
- | - [[ http:// | + | - [[ http:// |
- | - Connect | + | - Connect your FT2232 based programmer. If you use the Zybo board, connect the board. |
- Identify the USB serial converter, which connects to the JTAG bus | - Identify the USB serial converter, which connects to the JTAG bus | ||
* If you use the Zybo board, it should be follwing device: | * If you use the Zybo board, it should be follwing device: | ||
Line 16: | Line 16: | ||
* If you want to install the default driver choose "// | * If you want to install the default driver choose "// | ||
- | * Do not install a different driver for "//USB Serial Converter A//". It is driver for the UART connection | + | * Do not install a different driver for "//USB Serial Converter A//". It is probably the driver for the UART connection. |
===== Installation of OpenOCD ===== | ===== Installation of OpenOCD ===== | ||
- You can either compile OpenOCD from the [[http:// | - You can either compile OpenOCD from the [[http:// | ||
- Extract the archive to your computer | - Extract the archive to your computer | ||
- | - The executable binary is located under: ''/ | + | - The executable binary is located under: '' |
- | - The user manual is located under: ''/ | + | - The user manual is located under: '' |
- | - The start scripts for OpenOCD needs to point to the ''/ | + | - The start scripts for OpenOCD needs to point to the '' |