openocd:installation
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| openocd:installation [2018/08/24 15:25] – mgehrig2 | openocd:installation [2018/08/24 16:09] – mgehrig2 | ||
|---|---|---|---|
| Line 6: | Line 6: | ||
| ===== Installation of the USB driver ===== | ===== Installation of the USB driver ===== | ||
| - [[ http:// | - [[ http:// | ||
| - | - Connect | + | - Connect your FT2232 based programmer. If you use the Zybo board, connect the board. |
| - Identify the USB serial converter, which connects to the JTAG bus | - Identify the USB serial converter, which connects to the JTAG bus | ||
| * If you use the Zybo board, it should be follwing device: | * If you use the Zybo board, it should be follwing device: | ||
| Line 16: | Line 16: | ||
| * If you want to install the default driver choose "// | * If you want to install the default driver choose "// | ||
| - | * Do not install a different driver for "//USB Serial Converter A//". It is driver for the UART connection | + | * Do not install a different driver for "//USB Serial Converter A//". It is probably the driver for the UART connection. |
| ===== Installation of OpenOCD ===== | ===== Installation of OpenOCD ===== | ||
| - You can either compile OpenOCD from the [[http:// | - You can either compile OpenOCD from the [[http:// | ||
| - Extract the archive to your computer | - Extract the archive to your computer | ||
| - | - The executable binary is located under: ''/ | + | - The executable binary is located under: '' |
| - | - The user manual is located under: ''/ | + | - The user manual is located under: '' |
| - | - The start scripts for OpenOCD needs to point to the ''/ | + | - The start scripts for OpenOCD needs to point to the '' |
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
