This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
firstexample:first_example_microzed_deploy [2021/12/28 14:54] – [Deploying] ursgraf | firstexample:first_example_microzed_deploy [2021/12/28 14:55] – [Step by Step Instructions] ursgraf | ||
---|---|---|---|
Line 10: | Line 10: | ||
- Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers. | - Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers. | ||
- Create a deep project and setup the project configuration as given in [[first_example_microzed|Hello World on the Avnet MicroZed Board]]. | - Create a deep project and setup the project configuration as given in [[first_example_microzed|Hello World on the Avnet MicroZed Board]]. | ||
- | - Choose a configuration for the FPGA part to be included into the resulting image. \\ {{ chooseplfile.png? | + | - Choose a configuration for the FPGA part to be included into the resulting image. \\ {{ chooseplfile.png? |
- When creating the run configuration, | - When creating the run configuration, | ||
- Running the configuration will create a flash file. Its location is given by the image file setting in the configuration. It carries the name // | - Running the configuration will create a flash file. Its location is given by the image file setting in the configuration. It carries the name // |