This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
firstexample:first_example_microzed_deploy [2021/07/23 18:47] – [Step by Step Instructions] ursgraf | firstexample:first_example_microzed_deploy [2022/08/22 08:35] – ursgraf | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Deploying ====== | ====== Deploying ====== | ||
<box green 100%> | <box green 100%> | ||
- | As soon as you are done with your development, | + | As soon as you are done with your development, |
</ | </ | ||
- | The application | + | The application |
===== Step by Step Instructions ===== | ===== Step by Step Instructions ===== | ||
- | - Set the jumpers on your MicroZed board as follows \\ {{ jtagboot.png? | ||
- | - Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers. | ||
- Create a deep project and setup the project configuration as given in [[first_example_microzed|Hello World on the Avnet MicroZed Board]]. | - Create a deep project and setup the project configuration as given in [[first_example_microzed|Hello World on the Avnet MicroZed Board]]. | ||
- | - Choose a configuration for the FPGA part to be included into the resulting image. \\ {{ chooseplfile.png? | + | - Choose a configuration for the FPGA part to be included into the resulting image. \\ {{ chooseplfile.png? |
- | - When creating the run configuration, | + | - When creating the run configuration, |
- | - Running the configuration will create | + | - Running the configuration will create |
- | - Switch | + | - Now, you have to choose between using a SD card or the QSPI flash. |
- | - The program | + | |
- | - Switch | + | ==== Using the SD Card ==== |
+ | | ||
+ | - Set the jumpers on your MicroZed board as follows \\ {{ sdboot.png?200 |}}. \\ This will boot the device from the SD card. | ||
+ | - Cycle the power. | ||
+ | |||
+ | ==== Using the QSPI Flash ==== | ||
+ | - Follow the steps given in [[firstexample:boot_loader# | ||
+ | - Set the jumpers on your MicroZed board as follows \\ {{ qspiboot.png? | ||
+ | | ||
===== How Does the System Boot? ===== | ===== How Does the System Boot? ===== |