This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
firstexample:first_example_microzed_deploy [2021/05/18 10:49] – [Step by Step Instructions] ursgraf | firstexample:first_example_microzed_deploy [2021/12/28 14:55] – [Step by Step Instructions] ursgraf | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Deploying ====== | ====== Deploying ====== | ||
<box green 100%> | <box green 100%> | ||
- | As soon as you are done with your development, | + | As soon as you are done with your development, |
</ | </ | ||
- | The application together with the configuration of the FPGA is loaded upon power-up from the flash device. What must be done using this method? | + | The application together with the configuration of the FPGA is loaded upon power-up from the SD card or the flash device. What must be done using this method? |
===== Step by Step Instructions ===== | ===== Step by Step Instructions ===== | ||
Line 10: | Line 10: | ||
- Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers. | - Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers. | ||
- Create a deep project and setup the project configuration as given in [[first_example_microzed|Hello World on the Avnet MicroZed Board]]. | - Create a deep project and setup the project configuration as given in [[first_example_microzed|Hello World on the Avnet MicroZed Board]]. | ||
- | - Choose a configuration for the FPGA part to be included into the resulting image. \\ {{ chooseplfile.png? | + | - Choose a configuration for the FPGA part to be included into the resulting image. \\ {{ chooseplfile.png? |
- When creating the run configuration, | - When creating the run configuration, | ||
- | - Running the configuration will create a flash file. Its location is given by the image file setting in the configuration. It carries the name // | + | - Running the configuration will create a flash file. Its location is given by the image file setting in the configuration. It carries the name // |
- Switch the driver for your JTAG-HS3 adapter to //FTDI CDM//, see [[https:// | - Switch the driver for your JTAG-HS3 adapter to //FTDI CDM//, see [[https:// | ||
- The program to download can be found in the binaries of //Vivado// or the //Xilinx SDK//. You have to either install //Vivado// or //Xilinx SDK// which doesn' | - The program to download can be found in the binaries of //Vivado// or the //Xilinx SDK//. You have to either install //Vivado// or //Xilinx SDK// which doesn' |