This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
firstexample:first_example_microzed_deploy [2021/12/28 15:48] – ursgraf | firstexample:first_example_microzed_deploy [2021/12/30 09:44] – ursgraf | ||
---|---|---|---|
Line 15: | Line 15: | ||
==== Using the SD Card ==== | ==== Using the SD Card ==== | ||
- Copy the above generated file // | - Copy the above generated file // | ||
- | - Set the jumpers on your MicroZed board as follows \\ {{ qspiboot.png?200 |}}. \\ This will boot the device from the QSPI flash. | + | - Set the jumpers on your MicroZed board as follows \\ {{ sdboot.png?200 |}}. \\ This will boot the device from the QSPI flash. |
- Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers. | - Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers. | ||
==== Using the QSPI Flash ==== | ==== Using the QSPI Flash ==== | ||
- | - Switch | + | - Follow |
- | - The program to download can be found in the binaries of //Vivado// or the //Xilinx SDK//. You have to either install //Vivado// or //Xilinx SDK// which doesn' | + | |
- | - Switch the driver for the JTAG-HS3 back to //WinUSB//, see [[https:// | + | |
- Set the jumpers on your MicroZed board as follows \\ {{ qspiboot.png? | - Set the jumpers on your MicroZed board as follows \\ {{ qspiboot.png? | ||
- Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers. | - Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers. |