This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
firstexample:first_example_microzed [2022/11/24 16:14] – ursgraf | firstexample:first_example_microzed [2022/11/24 16:21] – ursgraf | ||
---|---|---|---|
Line 66: | Line 66: | ||
- Set the jumpers on your MicroZed board as follows \\ {{jtagboot.png? | - Set the jumpers on your MicroZed board as follows \\ {{jtagboot.png? | ||
- Connect your host machine with another USB cable to the MicroZed board on connector J2. This applies power to the target and creates a USB to UART bridge device (COM port). | - Connect your host machine with another USB cable to the MicroZed board on connector J2. This applies power to the target and creates a USB to UART bridge device (COM port). | ||
- | - Use a terminal program such as '' | + | - Use a terminal program such as '' |
- Create a new run configuration by marking the project file // | - Create a new run configuration by marking the project file // | ||
- | - //Run// will compile, link and download the image file. Downloading automatically starts OpenOCD, see [[openocd: | + | - //Run// will compile, link and download the image file. Downloading automatically starts OpenOCD. |
- The terminal window will show //Hello world//. | - The terminal window will show //Hello world//. | ||
- With {{run.jpg}} you can recompile and rerun the program. | - With {{run.jpg}} you can recompile and rerun the program. | ||