This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
firstexample:first_example_microzed [2020/12/09 21:25] – ursgraf | firstexample:first_example_microzed [2020/12/14 15:34] – ursgraf | ||
---|---|---|---|
Line 61: | Line 61: | ||
} | } | ||
</ | </ | ||
- | - Connect the hardware to your host machine by an USB cable and a JTAG-HS3 adapter (J3). | + | - Plug a [[https:// |
- | - Make sure that you select the //WinUSB// driver for your adapter [[https:// | + | - Make sure that you select the //WinUSB// driver for your JTAG-HS3 |
- | - Set the jumpers on your MicroZed board as follows \\ {{jtagboot.png? | + | - Set the jumpers on your MicroZed board as follows \\ {{jtagboot.png? |
+ | - Connect your host machine with another USB cable to the MicroZed board on connector | ||
- Start OpenOCD, see [[openocd: | - Start OpenOCD, see [[openocd: | ||
- | - Use a terminal program such as '' | + | - Use a terminal program such as '' |
- Create a new run configuration by marking the project file // | - Create a new run configuration by marking the project file // | ||
- //Run// will compile, link and download the image file. | - //Run// will compile, link and download the image file. |