This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
firstexample:first_example_microzed [2020/12/09 20:50] – ursgraf | firstexample:first_example_microzed [2020/12/09 21:25] – ursgraf | ||
---|---|---|---|
Line 63: | Line 63: | ||
- Connect the hardware to your host machine by an USB cable and a JTAG-HS3 adapter (J3). | - Connect the hardware to your host machine by an USB cable and a JTAG-HS3 adapter (J3). | ||
- Make sure that you select the //WinUSB// driver for your adapter [[https:// | - Make sure that you select the //WinUSB// driver for your adapter [[https:// | ||
- | - Set the jumpers on your MicroZed board as follows \\ {{:jtagboot.png? | + | - Set the jumpers on your MicroZed board as follows \\ {{jtagboot.png? |
- | - Start [[https:// | + | - Start OpenOCD, see [[openocd:starting_openocd|Starting |
- Use a terminal program such as '' | - Use a terminal program such as '' | ||
- Create a new run configuration by marking the project file // | - Create a new run configuration by marking the project file // |