deep

a Cross Development Platform for Java

User Tools

Site Tools

You are here: start » firstexample » first_example_microzed
firstexample:first_example_microzed

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
firstexample:first_example_microzed [2022/12/20 15:53] – ursgraffirstexample:first_example_microzed [2025/02/18 14:17] (current) – ursgraf
Line 61: Line 61:
 } }
 </code> </code>
-  - Plug a [[https://wiki.bu.ost.ch/infoportal/embedded_systems/jtaghs3/start|JTAG-HS3]] adapter into J3 of your board and connect it with your host machine by an USB cable. This will create a USB Serial Converter device on your machine.+  - Plug a [[https://wiki.ost.ch/display/EDS/Digilent+JTAG-HS3|JTAG-HS3]] adapter into J3 of your board and connect it with your host machine by an USB cable. This will create a USB Serial Converter device on your machine.
   - We use [[openocd:start|OpenOCD]] for downloading and debugging programs. Make sure to have it installed, see [[:installation#Install_Libraries_to_Access_the_Hardware|Download and Installation]]. Next, set the deep preferences so that the OpenOCD command and command options suits your installation, please refer to [[eclipse:perspective#Setting_Deep_Preferences|Setting Deep Preferences]] and [[openocd:starting_openocd|Starting OpenOCD]].   - We use [[openocd:start|OpenOCD]] for downloading and debugging programs. Make sure to have it installed, see [[:installation#Install_Libraries_to_Access_the_Hardware|Download and Installation]]. Next, set the deep preferences so that the OpenOCD command and command options suits your installation, please refer to [[eclipse:perspective#Setting_Deep_Preferences|Setting Deep Preferences]] and [[openocd:starting_openocd|Starting OpenOCD]].
-  - Make sure that you select the //WinUSB// driver for your JTAG-HS3 adapter [[https://wiki.bu.ost.ch/infoportal/embedded_systems/jtaghs3/start]].+  - Make sure that you select the //WinUSB// driver for your JTAG-HS3 adapter [[https://wiki.ost.ch/display/EDS/Digilent+JTAG-HS3]].
   - Set the jumpers on your MicroZed board as follows \\ {{jtagboot.png?200|}}. \\ This will boot the device from JTAG. The settings of the jumpers will be read only at powerup!    - Set the jumpers on your MicroZed board as follows \\ {{jtagboot.png?200|}}. \\ This will boot the device from JTAG. The settings of the jumpers will be read only at powerup! 
   - Connect your host machine with another USB cable to the MicroZed board on connector J2. This applies power to the target and creates a USB to UART bridge device (COM port).   - Connect your host machine with another USB cable to the MicroZed board on connector J2. This applies power to the target and creates a USB to UART bridge device (COM port).
firstexample/first_example_microzed.txt · Last modified: 2025/02/18 14:17 by ursgraf

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
CC Attribution-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki