deep

a Cross Development Platform for Java

User Tools

Site Tools

You are here: start » firstexample » first_example_microzed
firstexample:first_example_microzed

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
firstexample:first_example_microzed [2021/12/28 13:44] – ursgraffirstexample:first_example_microzed [2021/12/28 13:45] – ursgraf
Line 65: Line 65:
   - Set the jumpers on your MicroZed board as follows \\ {{jtagboot.png?200|}}. \\ This will boot the device from JTAG. The settings of the jumpers will be read only at powerup!    - Set the jumpers on your MicroZed board as follows \\ {{jtagboot.png?200|}}. \\ This will boot the device from JTAG. The settings of the jumpers will be read only at powerup! 
   - Connect your host machine with another USB cable to the MicroZed board on connector J2. This applies power to the target and creates a USB to UART bridge device (COM port).   - Connect your host machine with another USB cable to the MicroZed board on connector J2. This applies power to the target and creates a USB to UART bridge device (COM port).
-  - Start OpenOCD, see [[openocd:starting_openocd|Starting OpenOCD]]. 
   - Use a terminal program such as ''putty'' or ''realterm'' to open the COM-port on J2 (baudrate = 115200). Alternatively open a terminal program as an eclipse view. Select the appropriate COM port number. Check your host operating settings for this number. If there is no associated serial port yet - make sure, that you have the proper driver installed ([[https://www.silabs.com/community/interface/knowledge-base.entry.html/2016/12/30/downloading_cp210xd-ek07|Downloading CP210x drivers]]).   - Use a terminal program such as ''putty'' or ''realterm'' to open the COM-port on J2 (baudrate = 115200). Alternatively open a terminal program as an eclipse view. Select the appropriate COM port number. Check your host operating settings for this number. If there is no associated serial port yet - make sure, that you have the proper driver installed ([[https://www.silabs.com/community/interface/knowledge-base.entry.html/2016/12/30/downloading_cp210xd-ek07|Downloading CP210x drivers]]).
   - Create a new run configuration by marking the project file //HelloWorld.deep//. Then, right-click on it and choose //Run As -> Deep Application//. \\ {{runas_context.png?280|}} \\ If you already created such a run configuration you can select it from the pulldown menu of the run-button. \\ {{runas_pulldown.png?280|}} \\    - Create a new run configuration by marking the project file //HelloWorld.deep//. Then, right-click on it and choose //Run As -> Deep Application//. \\ {{runas_context.png?280|}} \\ If you already created such a run configuration you can select it from the pulldown menu of the run-button. \\ {{runas_pulldown.png?280|}} \\ 
firstexample/first_example_microzed.txt · Last modified: 2022/12/20 15:53 by ursgraf

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
CC Attribution-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki