This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
firstexample:first_example_microzed [2021/12/28 13:34] – ursgraf | firstexample:first_example_microzed [2021/12/28 13:45] – ursgraf | ||
---|---|---|---|
Line 53: | Line 53: | ||
programmertype = openOCD; | programmertype = openOCD; | ||
programmeropts = localhost_4444; | programmeropts = localhost_4444; | ||
- | imgfile = "D:\work\HelloWorld.bin"; | + | imgfile = "C:\EclipseUser\HelloWorld\HelloWorld"; |
# pl_file = none; | # pl_file = none; | ||
Line 65: | Line 65: | ||
- Set the jumpers on your MicroZed board as follows \\ {{jtagboot.png? | - Set the jumpers on your MicroZed board as follows \\ {{jtagboot.png? | ||
- Connect your host machine with another USB cable to the MicroZed board on connector J2. This applies power to the target and creates a USB to UART bridge device (COM port). | - Connect your host machine with another USB cable to the MicroZed board on connector J2. This applies power to the target and creates a USB to UART bridge device (COM port). | ||
- | - Start OpenOCD, see [[openocd: | ||
- Use a terminal program such as '' | - Use a terminal program such as '' | ||
- Create a new run configuration by marking the project file // | - Create a new run configuration by marking the project file // |