This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
firstexample:first_example_microzed [2021/12/28 13:21] – ursgraf | firstexample:first_example_microzed [2021/12/28 13:48] – ursgraf | ||
---|---|---|---|
Line 11: | Line 11: | ||
- Select a programmer: //OpenOCD// | - Select a programmer: //OpenOCD// | ||
- Select programmer options: // | - Select programmer options: // | ||
- | - Select the checkbox //Create image file// and choose the location to save the image file and the desired image file format, preferably //BIN//. Default save location is the project folder. | + | - Select the checkbox //Create image file// and choose the location to save the image file. Default save location is the project folder. |
+ | - Select | ||
- Project name: | - Project name: | ||
- Choose a project name (no spaces, no special characters such as " | - Choose a project name (no spaces, no special characters such as " | ||
Line 47: | Line 48: | ||
project HelloWorld { | project HelloWorld { | ||
- | libpath = "I:\deep\lib"; | + | libpath = "\\ost.ch\dfs\bsc.sys\public-programme\deep\lib"; |
boardtype = MicroZed; | boardtype = MicroZed; | ||
ostype = sts_arm; | ostype = sts_arm; | ||
programmertype = openOCD; | programmertype = openOCD; | ||
programmeropts = localhost_4444; | programmeropts = localhost_4444; | ||
- | imgfile = "D:\work\HelloWorld.bin"; | + | imgfile = "C:\EclipseUser\HelloWorld\HelloWorld"; |
# pl_file = none; | # pl_file = none; | ||
Line 64: | Line 65: | ||
- Set the jumpers on your MicroZed board as follows \\ {{jtagboot.png? | - Set the jumpers on your MicroZed board as follows \\ {{jtagboot.png? | ||
- Connect your host machine with another USB cable to the MicroZed board on connector J2. This applies power to the target and creates a USB to UART bridge device (COM port). | - Connect your host machine with another USB cable to the MicroZed board on connector J2. This applies power to the target and creates a USB to UART bridge device (COM port). | ||
- | - Start OpenOCD, see [[openocd: | ||
- Use a terminal program such as '' | - Use a terminal program such as '' | ||
- Create a new run configuration by marking the project file // | - Create a new run configuration by marking the project file // | ||
- | - //Run// will compile, link and download the image file. | + | - //Run// will compile, link and download the image file. Downloading automatically starts OpenOCD, see [[openocd: |
- | - The terminal window will show //Hello, World//. | + | - The terminal window will show // |
- With {{run.jpg}} you can recompile and rerun the program. | - With {{run.jpg}} you can recompile and rerun the program. | ||