This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
firstexample:boot_loader [2020/12/09 21:41] – [Flashing a new Boot Loader] ursgraf | firstexample:boot_loader [2021/03/15 17:03] – [Flashing a new Boot Loader] ursgraf | ||
---|---|---|---|
Line 14: | Line 14: | ||
- Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers. | - Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers. | ||
- Switch the driver for your JTAG-HS3 adapter to //FTDI CDM//, see [[https:// | - Switch the driver for your JTAG-HS3 adapter to //FTDI CDM//, see [[https:// | ||
- | - Open a command shell and run the command (Change the command so that the right configuration file is loaded, see [[https:// | + | - Open a command shell and run the command (Change the command so that the right configuration file is loaded, see [[https:// |
- Switch the driver for the JTAG-HS3 back to //WinUSB//, see [[https:// | - Switch the driver for the JTAG-HS3 back to //WinUSB//, see [[https:// |