This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
openocd:starting_openocd [2020/12/09 22:00] – [Starting OpenOCD] ursgraf | openocd:starting_openocd [2022/11/24 16:06] (current) – ursgraf | ||
---|---|---|---|
Line 3: | Line 3: | ||
* to the command line interface of OpenOCD with a telnet connection on port 4444 | * to the command line interface of OpenOCD with a telnet connection on port 4444 | ||
* to the GDB server on port 3333 | * to the GDB server on port 3333 | ||
- | ===== Windows | + | |
+ | OpenOCD is started automatically when downloading to a Zynq7000 based board. Alternatively you can start OpenOCD as follows: | ||
+ | ==== Windows ==== | ||
Navigate to your '' | Navigate to your '' | ||
* On the Zybo board start '' | * On the Zybo board start '' | ||
* On the Microzed board start '' | * On the Microzed board start '' | ||
- | These commands will | ||
- | With a telnet connection on localhost: | ||
- | |||
- | The gdb connects over port 3333. | ||
- | ===== Linux ===== | + | ==== Linux ==== |
- | Run OpenOCD with the correct config file: | + | Navigate to your '' |
- | cd / | + | * On the Zybo board start with '' |
- | sudo openocd -f microzedboard.cfg | + | * On the Microzed board start with '' |
+ | Alternatively, | ||
+ | * '' | ||
+ | * '' | ||