openocd:starting_openocd
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
| openocd:starting_openocd [2020/12/09 22:03] – [Linux] ursgraf | openocd:starting_openocd [2021/12/28 13:52] – ursgraf | ||
|---|---|---|---|
| Line 4: | Line 4: | ||
| * to the GDB server on port 3333 | * to the GDB server on port 3333 | ||
| - | Start OpenOCD as follows: | + | OpenOCD is started automatically when downloading to a Zynq7000 based board. Alternatively you can start OpenOCD as follows: |
| - | ===== Windows | + | ==== Windows ==== |
| Navigate to your '' | Navigate to your '' | ||
| * On the Zybo board start '' | * On the Zybo board start '' | ||
| Line 11: | Line 11: | ||
| - | ===== Linux ===== | + | ==== Linux ==== |
| Navigate to your '' | Navigate to your '' | ||
| - | * On the Zybo board start with \\ '' | + | * On the Zybo board start with '' |
| - | * On the Microzed board start with \\ '' | + | * On the Microzed board start with '' |
openocd/starting_openocd.txt · Last modified: 2022/11/24 16:06 by ursgraf
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
