This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
openocd:starting_openocd [2020/12/09 21:56] – ursgraf | openocd:starting_openocd [2020/12/09 22:00] – [Windows] ursgraf | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Starting OpenOCD ====== | ====== Starting OpenOCD ====== | ||
- | Start the OpenOCD server | + | OpenOCD runs a server to which you can connect |
+ | * to the command line interface of OpenOCD | ||
+ | * to the GDB server | ||
+ | Start OpenOCD as follows: | ||
===== Windows ===== | ===== Windows ===== | ||
Navigate to your '' | Navigate to your '' | ||
Line 7: | Line 10: | ||
* On the Microzed board start '' | * On the Microzed board start '' | ||
- | These commands will | ||
- | With a telnet connection on localhost: | ||
- | |||
- | The gdb connects over port 3333. | ||
===== Linux ===== | ===== Linux ===== |