openocd:start
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| openocd:start [2020/12/10 07:04] – [Using GDB Connection] ursgraf | openocd:start [2021/01/14 16:37] (current) – [OpenOCD] ursgraf | ||
|---|---|---|---|
| Line 4: | Line 4: | ||
| * [[: | * [[: | ||
| * [[openocd: | * [[openocd: | ||
| - | * [[openocd:installation_gdb|]] | + | * [[openocd:using_openocd|Details of Using OpenOCD]] |
| - | * [[openocd: | + | |
| The hardware adapter forms the electrical interface to the processor and must also be matched to the processor. The adapter is already integrated on the Zybo board. For the Microzed board you need a [[https:// | The hardware adapter forms the electrical interface to the processor and must also be matched to the processor. The adapter is already integrated on the Zybo board. For the Microzed board you need a [[https:// | ||
| Line 27: | Line 25: | ||
| The "GNU Arm Embedded Toolchain" | The "GNU Arm Embedded Toolchain" | ||
| - | + | === How to Use the GDB === | |
| - | More information under [[.: | + | [[.: |
openocd/start.1607580263.txt.gz · Last modified: 2020/12/10 07:04 by ursgraf
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
