firstexample:first_example_microzed_sysdev
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| firstexample:first_example_microzed_sysdev [2022/02/16 15:57] – [System Developer] ursgraf | firstexample:first_example_microzed_sysdev [2022/11/24 16:23] (current) – [Step by Step Instructions] ursgraf | ||
|---|---|---|---|
| Line 6: | Line 6: | ||
| ===== Step by Step Instructions ===== | ===== Step by Step Instructions ===== | ||
| - | - Create a deep project and setup the project configuration as given in [[first_example_microzed|Hello World on the Avnet MicroZed Board]]. Make sure that you have set the OpenOCD command and command options so that it suits your installation, | + | - Create a deep project and setup the project configuration as given in [[first_example_microzed|Hello World on the Avnet MicroZed Board]]. Make sure that you have set the OpenOCD command and command options so that it suits your installation, |
| - If you need a valid configuration in your FPGA part (e.g. you are using flink devices), you must select a configuration file for the PL. \\ {{ chooseplfile.png? | - If you need a valid configuration in your FPGA part (e.g. you are using flink devices), you must select a configuration file for the PL. \\ {{ chooseplfile.png? | ||
| - Set the jumpers on your MicroZed board as follows \\ {{ jtagboot.png? | - Set the jumpers on your MicroZed board as follows \\ {{ jtagboot.png? | ||
firstexample/first_example_microzed_sysdev.txt · Last modified: 2022/11/24 16:23 by ursgraf
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
