firstexample:first_example_microzed_appdev
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| firstexample:first_example_microzed_appdev [2021/12/28 16:35] – [Step by Step Instructions] ursgraf | firstexample:first_example_microzed_appdev [2024/02/13 13:01] (current) – [Application Development] ursgraf | ||
|---|---|---|---|
| Line 4: | Line 4: | ||
| </ | </ | ||
| - | While you can load and test new custom applications quickly, the configuration of the FPGA is loaded from the QSPI flash. This saves time compared to using the method [[first_example_microzed_sysdev|System Developer]]. | + | While you can load and test new custom applications quickly, the configuration of the FPGA is loaded from the QSPI flash. This saves time compared to using the method [[first_example_microzed_sysdev|System Developer]]. |
| ===== Step by Step Instructions ===== | ===== Step by Step Instructions ===== | ||
| Line 10: | Line 10: | ||
| - Set the jumpers on your MicroZed board as follows \\ {{ qspiboot.png? | - Set the jumpers on your MicroZed board as follows \\ {{ qspiboot.png? | ||
| - Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers. | - Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers. | ||
| - | - Create a deep project and setup the project configuration as given in [[first_example_microzed|Hello World on the Avnet MicroZed Board]]. | + | - Create a deep project and setup the project configuration as given in [[first_example_microzed|Hello World on the Avnet MicroZed Board]]. |
| - Do not specify a configuration for the FPGA part, as it will be loaded from flash. \\ {{ choosenoplfile.png? | - Do not specify a configuration for the FPGA part, as it will be loaded from flash. \\ {{ choosenoplfile.png? | ||
| - When creating the run configuration, | - When creating the run configuration, | ||
firstexample/first_example_microzed_appdev.1640705722.txt.gz · Last modified: 2021/12/28 16:35 by ursgraf
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
