This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
firstexample:first_example_microzed_appdev [2021/12/28 16:31] – [Step by Step Instructions] ursgraf | firstexample:first_example_microzed_appdev [2022/11/24 16:24] – [Step by Step Instructions] ursgraf | ||
---|---|---|---|
Line 10: | Line 10: | ||
- Set the jumpers on your MicroZed board as follows \\ {{ qspiboot.png? | - Set the jumpers on your MicroZed board as follows \\ {{ qspiboot.png? | ||
- Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers. | - Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers. | ||
- | - Create a deep project and setup the project configuration as given in [[first_example_microzed|Hello World on the Avnet MicroZed Board]]. | + | - Create a deep project and setup the project configuration as given in [[first_example_microzed|Hello World on the Avnet MicroZed Board]]. |
- Do not specify a configuration for the FPGA part, as it will be loaded from flash. \\ {{ choosenoplfile.png? | - Do not specify a configuration for the FPGA part, as it will be loaded from flash. \\ {{ choosenoplfile.png? | ||
- When creating the run configuration, | - When creating the run configuration, | ||
+ | - //Run// will compile, link and download the image file. See [[firstexample: | ||
===== How Does the System Boot? ===== | ===== How Does the System Boot? ===== | ||
- reset (by JTAG) | - reset (by JTAG) |