This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
firstexample:boot_loader [2021/03/15 17:04] – [Flashing a new Boot Loader] ursgraf | firstexample:boot_loader [2021/05/18 10:49] – [Flashing a new Boot Loader] ursgraf | ||
---|---|---|---|
Line 14: | Line 14: | ||
- Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers. | - Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers. | ||
- Switch the driver for your JTAG-HS3 adapter to //FTDI CDM//, see [[https:// | - Switch the driver for your JTAG-HS3 adapter to //FTDI CDM//, see [[https:// | ||
- | - The program to download can be found in the binaries of //Vivado// or the //Xilinx SDK//. You have to either install //Vivado// or //Xilinx SDK// which doesn' | + | - The program to download can be found in the binaries of //Vivado// or the //Xilinx SDK//. You have to either install //Vivado// or //Xilinx SDK// which doesn' |
- Switch the driver for the JTAG-HS3 back to //WinUSB//, see [[https:// | - Switch the driver for the JTAG-HS3 back to //WinUSB//, see [[https:// |