first_example_mpc5200
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| first_example_mpc5200 [2020/09/11 17:18] – ursgraf | first_example_mpc5200 [2020/09/11 17:20] – ursgraf | ||
|---|---|---|---|
| Line 68: | Line 68: | ||
| - The terminal window will show //Hello, World//. | - The terminal window will show //Hello, World//. | ||
| - With {{run.jpg}} you can recompile and rerun the programm. | - With {{run.jpg}} you can recompile and rerun the programm. | ||
| - | - | ||
| - | - //Run// will compile, link and create the image file. . | ||
| + | ===== Downloading without Debugger ===== | ||
| If the boot loader //uBoot// is present on the board, it will start up and configure the memory and clocks. Now, it's possible to download a program without using an Abatron device. For this, you have to choose in step 4 the target configuration //Phytec PhiCORE-MPC5200uBoot// | If the boot loader //uBoot// is present on the board, it will start up and configure the memory and clocks. Now, it's possible to download a program without using an Abatron device. For this, you have to choose in step 4 the target configuration //Phytec PhiCORE-MPC5200uBoot// | ||
| Connect a terminal program on PSC3 with 115200, no parity, 8 bit. Also connect the Ethernet of the board to your local server, which must have a TFTP server running. Run the following command: < | Connect a terminal program on PSC3 with 115200, no parity, 8 bit. Also connect the Ethernet of the board to your local server, which must have a TFTP server running. Run the following command: < | ||
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
