This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
first_example_mpc5200 [2020/09/11 13:11] – ursgraf | first_example_mpc5200 [2020/09/11 17:18] – ursgraf | ||
---|---|---|---|
Line 61: | Line 61: | ||
} | } | ||
</ | </ | ||
- | - Connect the hardware to your host PC by an USB cable and apply power to the target. | + | - Connect the target through |
+ | - Install | ||
- Open a terminal program such as '' | - Open a terminal program such as '' | ||
- Create a new run configuration by marking the project file // | - Create a new run configuration by marking the project file // | ||
Line 67: | Line 68: | ||
- The terminal window will show //Hello, World//. | - The terminal window will show //Hello, World//. | ||
- With {{run.jpg}} you can recompile and rerun the programm. | - With {{run.jpg}} you can recompile and rerun the programm. | ||
- | - //Run// will compile, link and create the image file. Use an external debugging device such as an [[http:// | + | |
+ | | ||
If the boot loader //uBoot// is present on the board, it will start up and configure the memory and clocks. Now, it's possible to download a program without using an Abatron device. For this, you have to choose in step 4 the target configuration //Phytec PhiCORE-MPC5200uBoot// | If the boot loader //uBoot// is present on the board, it will start up and configure the memory and clocks. Now, it's possible to download a program without using an Abatron device. For this, you have to choose in step 4 the target configuration //Phytec PhiCORE-MPC5200uBoot// |