Sidebar
first_example_microzed_sysdev
This is an old revision of the document!
System Developer
This is the method to choose when working on new low-level drivers, kernel improvements or new FPGA configurations.
In such cases you have to control the board in by your host development system right upon a POR (power-on reset). In this mode you have full control over every every part of the hardware. However, it will take time to set everything up after booting. Notably, the FPGA configuration has to loaded through JTAG each time you load a new program.
For this you have to set the jumpers on your MicroZed board as follows
.
This will boot the device from JTAG. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers.
first_example_microzed_sysdev.1606804828.txt.gz · Last modified: 2020/12/01 07:40 by ursgraf
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
