first_example_microzed_sysdev
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
| first_example_microzed_sysdev [2020/11/19 19:53] – created ursgraf | first_example_microzed_sysdev [Unknown date] (current) – removed - external edit (Unknown date) 127.0.0.1 | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== System Developer ====== | ||
| - | When working on new low-level drivers, kernel improvements or FPGA configurations you have to control the board upon a POR (power-on reset). For this you have to set the jumpers on your MicroZed board as follows \\ {{: | ||
first_example_microzed_sysdev.1605812029.txt.gz · Last modified: 2020/11/19 19:53 by ursgraf
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
