first_example_microzed_sysdev
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
| first_example_microzed_sysdev [2020/12/01 10:49] – [Step by Step Instructions] ursgraf | first_example_microzed_sysdev [2020/12/01 10:56] – [How does the System Boot?] ursgraf | ||
|---|---|---|---|
| Line 10: | Line 10: | ||
| - Create a deep project and setup the project configuration as given in [[first_example_microzed|Hello World on the Avnet MicroZed Board]]. | - Create a deep project and setup the project configuration as given in [[first_example_microzed|Hello World on the Avnet MicroZed Board]]. | ||
| - If you need a valid configuration in your FPGA part (e.g. you are using flink devices), you must select a configuration file for the PL. \\ {{ :: | - If you need a valid configuration in your FPGA part (e.g. you are using flink devices), you must select a configuration file for the PL. \\ {{ :: | ||
| - | - When creating the run configuration, | + | - When creating the run configuration, |
| + | |||
| + | ===== How Does the System Boot? ===== | ||
| + | - reset (by JTAG) | ||
| + | - configuration of PLL, clocks, DDR by host system | ||
| + | - download of bin-files to OCM and DDR | ||
| + | - download of bit-file (if specified) | ||
| + | - start at address 0x100 | ||
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
