Differences

This shows you the differences between two versions of the page.

--- first_example_microzed_sysdev [2020/11/19 20:06] – ursgraf
+++ first_example_microzed_sysdev [Unknown date] (current) – removed - external edit (Unknown date) 127.0.0.1
@@ Line 1: / Line 1: @@
-====== System Developer ======
-This is the method to choose when working on new low-level drivers, kernel improvements or new FPGA configurations. In such cases you have to control the board in by your host development system right upon a POR (power-on reset). For this you have to set the jumpers on your MicroZed board as follows \\ {{ :jtagboot.png?200 |}}. \\ This will boot the device from JTAG. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers.

deep