The application together with the configuration of the FPGA is loaded upon power-up from the flash device. What must be done using this method?

1. Set the jumpers on your MicroZed board as follows
   .
   This will boot the device from the QSPI flash.
2. Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers.
3. Create a deep project and setup the project configuration as given in Hello World on the Avnet MicroZed Board.
4. Do not specify a configuration for the FPGA part, as it will be loaded from flash. you must select a configuration file for the PL.
   .
5. When creating the run configuration, set the target configuration to boot from QSPI flash and load program to ram .

1. reset (by JTAG)
2. load and run first stage boot loader from flash
   1. configuration of PLL, clocks, DDR by host system
   2. load PL
   3. handoff to JTAG
3. halt
4. reset REBOOT_STATUS register
5. download of bin-files to OCM and DDR
6. download of bit-file (if specified)
7. start at address 0x100