first_example_microzed_appdev
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| first_example_microzed_appdev [2020/12/01 14:28] – [Step by Step Instructions] ursgraf | first_example_microzed_appdev [Unknown date] (current) – removed - external edit (Unknown date) 127.0.0.1 | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== Application Development ====== | ||
| - | <box green 100%> | ||
| - | This is the preferred method when writing applications on the MicroZed board using the existing runtime library together with the board support package. | ||
| - | </ | ||
| - | |||
| - | While you can load and test new custom applications quickly, the configuration of the FPGA is loaded from a flash device. This saves time compared to using the method [[first_example_microzed_sysdev|System Developer]]. What must be done when using this method? | ||
| - | |||
| - | ===== Step by Step Instructions ===== | ||
| - | - Make sure that you have a default boot loader in your flash device, see [[boot_loader]]. This must be done only once as long as you don't overwrite it. | ||
| - | - Set the jumpers on your MicroZed board as follows \\ {{ : | ||
| - | - Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers. | ||
| - | - Create a deep project and setup the project configuration as given in [[first_example_microzed|Hello World on the Avnet MicroZed Board]]. | ||
| - | - Do not specify a configuration for the FPGA part, as it will be loaded from flash. you must select a configuration file for the PL. \\ {{ :: | ||
| - | - When creating the run configuration, | ||
| - | |||
| - | ===== How Does the System Boot? ===== | ||
| - | - reset (by JTAG) | ||
| - | - load and run first stage boot loader from flash | ||
| - | - configuration of PLL, clocks, DDR by host system | ||
| - | - load PL | ||
| - | - handoff to JTAG | ||
| - | - halt | ||
| - | - reset REBOOT_STATUS register | ||
| - | - download of bin-files to OCM and DDR | ||
| - | - download of bit-file (if specified) | ||
| - | - start at address 0x100 | ||
first_example_microzed_appdev.1606829338.txt.gz · Last modified: 2020/12/01 14:28 by ursgraf
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
