deep

a Cross Development Platform for Java

User Tools

Site Tools


first_example_microzed_appdev

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Last revisionBoth sides next revision
first_example_microzed_appdev [2020/12/01 14:13] – [How Does the System Boot?] ursgraffirst_example_microzed_appdev [2020/12/01 14:28] – [Step by Step Instructions] ursgraf
Line 7: Line 7:
    
 ===== Step by Step Instructions ===== ===== Step by Step Instructions =====
 +  - Make sure that you have a default boot loader in your flash device, see [[boot_loader]]. This must be done only once as long as you don't overwrite it. 
   - Set the jumpers on your MicroZed board as follows \\ {{ :qspiboot.png?200 |}}. \\ This will boot the device from the QSPI flash.    - Set the jumpers on your MicroZed board as follows \\ {{ :qspiboot.png?200 |}}. \\ This will boot the device from the QSPI flash. 
   - Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers.   - Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers.