This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
first_example_microzed_appdev [2020/12/01 14:09] – [Step by Step Instructions] ursgraf | first_example_microzed_appdev [2020/12/01 14:11] – [Step by Step Instructions] ursgraf | ||
---|---|---|---|
Line 10: | Line 10: | ||
- Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers. | - Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers. | ||
- Create a deep project and setup the project configuration as given in [[first_example_microzed|Hello World on the Avnet MicroZed Board]]. | - Create a deep project and setup the project configuration as given in [[first_example_microzed|Hello World on the Avnet MicroZed Board]]. | ||
- | - Do not specify a configuration for the FPGA part, as it will be loaded from flash. you must select a configuration file for the PL. \\ {{ :: | + | - Do not specify a configuration for the FPGA part, as it will be loaded from flash. you must select a configuration file for the PL. \\ {{ :: |
- | - When creating the run configuration, | + | - When creating the run configuration, |
===== How Does the System Boot? ===== | ===== How Does the System Boot? ===== |