deep

a Cross Development Platform for Java

User Tools

Site Tools


first_example_microzed_appdev

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
first_example_microzed_appdev [2020/12/01 14:09] – [Step by Step Instructions] ursgraffirst_example_microzed_appdev [2020/12/01 14:10] – [Step by Step Instructions] ursgraf
Line 10: Line 10:
   - Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers.   - Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers.
   - Create a deep project and setup the project configuration as given in [[first_example_microzed|Hello World on the Avnet MicroZed Board]].    - Create a deep project and setup the project configuration as given in [[first_example_microzed|Hello World on the Avnet MicroZed Board]]. 
-  - Do not specify a configuration for the FPGA part, as it will be loaded from flash. you must select a configuration file for the PL. \\ {{ ::choosenoplfile.png?300 |}} \\ Available configurations can be found under [[https://wiki.bu.ost.ch/infoportal/embedded_systems/zynq7000/microzed]].+  - Do not specify a configuration for the FPGA part, as it will be loaded from flash. you must select a configuration file for the PL. \\ {{ ::choosenoplfile.png?300 |}}.
   - When creating the run configuration, set the target configuration to //load program to ram// {{ :runconfigurationmicrozedram.png?400 |}}.   - When creating the run configuration, set the target configuration to //load program to ram// {{ :runconfigurationmicrozedram.png?400 |}}.