first_example_microzed_appdev
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| first_example_microzed_appdev [2020/12/01 13:46] – [Application Development] ursgraf | first_example_microzed_appdev [2020/12/01 13:47] – [Step by Step Instructions] ursgraf | ||
|---|---|---|---|
| Line 7: | Line 7: | ||
| ===== Step by Step Instructions ===== | ===== Step by Step Instructions ===== | ||
| - | - Set the jumpers on your MicroZed board as follows \\ {{ :jtagboot.png?200 |}}. \\ This will boot the device from JTAG. | + | - Set the jumpers on your MicroZed board as follows \\ {{ :qspiboot.png?200 |}}. \\ This will boot the device from the QSPI flash. |
| - Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers. | - Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers. | ||
| - Create a deep project and setup the project configuration as given in [[first_example_microzed|Hello World on the Avnet MicroZed Board]]. | - Create a deep project and setup the project configuration as given in [[first_example_microzed|Hello World on the Avnet MicroZed Board]]. | ||
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
